Uses three 8mm 1.25 thread 20mm long bolts to attach to the mounting plate.

Specifications

Input Torque: 0-5.16 Ft Lbs / 0-7Nm
Output Torque: 0-28.77 Ft Lbs / 0-39Nm
ECU Voltage: 10-16v
ECU Current: 30A
Motor Voltage: 12v
Motor Current: 30A
Motor Power: 220w

This electric power steering kit features a universal mounting plate that will fit most off road applications. The side with the torque input sensor faces TOWARDS the driver. It will drastically reduce steering effort, allowing for longer more enjoyable rides without robbing horsepower like conventional hydraulic power steering.

This electric power steering kit has a sealed input and output shaft as well as a unique injection molded computer control box seal for a water resistant and sand sealed setup. The input and output shafts are 17mm x 36 spline and will work with most aftermarket rack & pinions.

Extremely simple wiring. All wiring that goes from the electric power steering computer to the electric power steering motor have special plugs that only fit specific ports. There are only 3 wires that you have to be concerned with. A white wire that goes to ignition ON. A red wire that goes directly to your battery. A black wire that goes directly to your battery. Maximum current draw is 18.33amps (220w divided by 12v equals 18.33amps) when steering wheel is turned completely to left or right. Normal operating amperage is far less.

NOTE: The red and black wires must go directly to the battery. Do NOT wire the computer to your fuse box. Wiring the computer to the fuse box allows for a short voltage drop that turns the unit off intermittently. Do NOT cut the wires that lead from the computer to the motor. Any alterations to those wires voids any warranty.

ez-steer ez steer ezsteer super atv superatv super-atv