Billet Bump Steer Tie Rod Mounting Bracket For Our Center Load Rack And Pinions 1-3/4" To 11"
California Prop 65 Warning: This item may cause cancer or reproductive harm. For more info visit p65warnings.ca.gov
Description
Heim joint spreaders give you correct geometry as your suspension goes through the wheel travel. They prevent the tires from toe in and toe out which results in bump steer.
This bump steer bracket was used on Buggy Works, Desert Dynamics, and Desert Rat Buggies a-arm sand rails. The back side indexes over 3/4" diameter bosses on the rack.
This bump steer bracket was used on Buggy Works, Desert Dynamics, and Desert Rat Buggies a-arm sand rails. The back side indexes over 3/4" diameter bosses on the rack.
-
Dimensions:
- 12-3/4" Total length
- 1-3/4" center to center for the rack
- 11" center to center for the tie rods
- 1/2"-13 x 1-3/4" coarse thread bolts required for tie rods
- 1/2"-20 x 3" fine thread bolts required to mount to rack
- 1-1/4" thick at the center
- Uses KMX128 or RSMX10-8T heim joints