Billet Bump Steer Tie Rod Mounting Bracket For Our Center Load Rack And Pinions 1-3/4" To 5-7/8"
No longer available. Listed for reference only.
Estimate Shipping
Price: $84.99
Call or email for availability
Sold As:
1 Bump Steer Bracket
Part Number: PRMDDABS9 EXTREME
OUT OF STOCK
California Prop 65 Warning: This item may cause cancer or reproductive harm. For more info visit p65warnings.ca.gov
Description
Heim joint spreaders give you correct geometry as your suspension goes through the wheel travel. They prevent the tires from toe in and toe out which results in bump steer.
This bump steer bracket was used on Allan Nimmo's Extreme Performance a-arm sand rails. The back side indexes over 3/4" diameter bosses on the rack.
This bump steer bracket was used on Allan Nimmo's Extreme Performance a-arm sand rails. The back side indexes over 3/4" diameter bosses on the rack.
-
Dimensions:
- 10-7/8" Total length
- 1-3/4" center to center for the rack
- 5-7/8" center to center for the tie rods
- 5/8"-18 x 1-1/2" fine thread bolts required for tie rods
- 1/2"-20 x 3-1/2" fine thread bolts required to mount to rack
- 1-3/4" thick at the center
- Uses KMX1210, RSMX10T, XAM10T, or RXAM-10T heim joints
Related Parts
FK Rod Ends 3/4" Right Hand Thread 5/8" Hole KMX12-10 Nylon Coated Heim Joints
In Stock
Price: $22.99
FK Rod Ends 3/4" Right Hand Thread 5/8" Hole RSMX10T PTFE Coated Chromoly Heim Joints F2 Fit
In Stock
Price: $41.99
Kartek Offroad 1.5:1 Ratio Hard Anodized Center Load Rack And Pinion For A-Arm Sand Cars
In Stock
Price: $439.99
Kartek Offroad 1.5:1 Ratio Polished Center Load Rack And Pinion For A-Arm Sand Cars
In Stock
Price: $379.99
