Fox Racing Shocks 3" Coil Over Body 12" Stroke 1" Diameter Shaft With Hose Remote Reservoir
Estimate Shipping
Price: $1,894.96
4 In Stock
Sold As:
1 Fox Coil-Over Shock
Part Number: FOX98130101
MFG Number:
981-30-101
California Prop 65 Warning: This item may cause cancer or reproductive harm. For more info visit p65warnings.ca.gov
Description
Supersedes Fox Part Number 980-02-167
From the finish line at the Indy 500 to the deserts of Dakar, FOX coil-over shocks have proven themselves as winners year after year. FOX engineers work only with the best spring manufacturers to develop winning spring/shock combinations. Whether you are upgrading your daily driver or building an unlimited trophy truck, FOX has a coil-over shock to fit your needs.
Factory Race Series 981-30-101 Dimensions:
Setup For Dual Spring Rate
3.0" Diameter
12.0" Travel
33.500" Extended
21.500" Collapsed
3" x 12" Reservoir
18" Reservoir Hose
1" Shaft Diameter
1-1/2" Mounting Width Between Tabs
Uses 5/8" Shock Bolts
27" Maximum combined total spring length
Typically customers purchase an 8" top spring and a 18" bottom spring. You could run a shorter bottom spring, but anything less than 18", using the flat spring perch, would have the bottom spring flopping on the spring guide because the spring divider will hit the spring guide at full extension.
If you purchase the cone shaped spring perch number 234-00-324 you would run a 2" shorter bottom spring. For example 8" top and 16" bottom.
Setup For Dual Spring Rate
3.0" Diameter
12.0" Travel
33.500" Extended
21.500" Collapsed
3" x 12" Reservoir
18" Reservoir Hose
1" Shaft Diameter
1-1/2" Mounting Width Between Tabs
Uses 5/8" Shock Bolts
27" Maximum combined total spring length
Typically customers purchase an 8" top spring and a 18" bottom spring. You could run a shorter bottom spring, but anything less than 18", using the flat spring perch, would have the bottom spring flopping on the spring guide because the spring divider will hit the spring guide at full extension.
If you purchase the cone shaped spring perch number 234-00-324 you would run a 2" shorter bottom spring. For example 8" top and 16" bottom.
End Loop and Perch Info
The shock comes with a flat bottom spring perch part number 234-00-318-A but you can also purchase the cone shaped spring perch number 234-00-324 to help with clearance issues.
The shock comes with the 2-1/2" top edge to center short bottom end loop part number 213-01-234-A. You can also purchase any of the longer end loops listed below. Even the end loops for 2.5" shocks will work but you'll also have to purchase AGM's spring perches. Keep in mind that if you switch from a standard 3.0" end loop that uses a 3/4" uniball to a 2.5" end loop, you'll also have to change the uniball to 5/8" and the 2.5" loops aren't nearly as strong as the 3.0"
