Fox Racing Shocks 3" Coil Over Body 14" Stroke 1" Diameter Shaft With Hose Remote Reservoir

Factory Race Series 981-30-102 Dimensions:
Setup For Dual Spring Rate
3.0" Diameter
14.0" Travel
38.500" Extended
24.500" Collapsed
3" x 14" Reservoir
18" Reservoir Hose
1" Shaft Diameter
1-1/2" Mounting Width Between Tabs
Uses 5/8" Shock Bolts

32" Maximum combined total spring length
Typically customers purchase a 12" top spring and a 20" bottom spring or 10" top spring and 22" bottom spring. You could run a shorter bottom spring, but anything less than 20", using the flat spring perch, would have the bottom spring flopping on the spring guide because the spring divider will hit the spring guide at full extension.

If you purchase the cone shaped spring perch number 234-00-324 you would run a 2" shorter bottom spring. For example 12" top and 18" bottom or 10" top and 20" bottom.

End Loop and Perch Info

The shock comes with a flat bottom spring perch part number 234-00-318-A but you can also purchase the cone shaped spring perch number 234-00-324 to help with clearance issues.

The shock comes with the 2-1/2" top edge to center short bottom end loop part number 213-01-234-A. You can also purchase any of the longer end loops listed below. Even the end loops for 2.5" shocks will work but you'll also have to purchase AGM's spring perches. Keep in mind that if you switch from a standard 3.0" end loop that uses a 3/4" uniball to a 2.5" end loop, you'll also have to change the uniball to 5/8" and the 2.5" loops aren't nearly as strong as the 3.0"