Fox Racing Shocks 3" Coil Over Body 16" Stroke 1" Diameter Shaft With Hose Remote Reservoir

Factory Race Series 981-30-103 Dimensions:
Setup For Dual Spring Rate
3.0" Diameter
16.0" Travel
42.500" Extended
26.500" Collapsed
3" x 16" Reservoir
18" Reservoir Hose
1" Shaft Diameter
1-1/2" Mounting Width Between Tabs
Uses 5/8" Shock Bolts

36" Maximum combined total spring length
Typically customers purchase a 14" top spring and a 22" bottom spring or 12" top spring and 24" bottom spring. You could run a shorter bottom spring, but anything less than 22", using the flat spring perch, would have the bottom spring flopping on the spring guide because the spring divider will hit the spring guide at full extension.

If you purchase the cone shaped spring perch number 234-00-324 you would run a 2" shorter bottom spring. For example 14" top and 20" bottom or 12" top and 22" bottom.

End Loop and Perch Info

The shock comes with a flat bottom spring perch part number 234-00-318-A but you can also purchase the cone shaped spring perch number 234-00-324 to help with clearance issues.

The shock comes with the 2-1/2" top edge to center short bottom end loop part number 213-01-234-A. You can also purchase any of the longer end loops listed below. Even the end loops for 2.5" shocks will work but you'll also have to purchase AGM's spring perches. Keep in mind that if you switch from a standard 3.0" end loop that uses a 3/4" uniball to a 2.5" end loop, you'll also have to change the uniball to 5/8" and the 2.5" loops aren't nearly as strong as the 3.0"