Fox Racing Shocks Internal Bypass 3" Coil Over 12" Stroke 7/8" Shaft With DSC Hose Remote Reservoir
Estimate Shipping
Price: $1,549.96
Call or email for availability
Sold As:
1 Fox Coil-Over Shock
Part Number: FOX981306023
MFG Number:
981-30-602-3
California Prop 65 Warning: This item may cause cancer or reproductive harm. For more info visit p65warnings.ca.gov
Description
Supersedes Fox Part Number 983-06-010
FOX internal bypass coil-over shocks combine the ability to adjust ride height through spring rate and preload while also delivering position-sensitive damping control in independently controlled stages. The internal bypass coil-over is ideal for vehicles that can only fit one shock per wheel, but require increased suspension damping control.
Factory Race Series 981-30-602-3 Dimensions:
Setup For Dual Spring Rate
3.0" Diameter
12.0" Travel
32.500" Extended
20.400" Collapsed
2-1/2" x 10" DSC Dual Speed Compression Reservoir
18" Reservoir Hose
7/8" Shaft Diameter
1-1/2" Mounting Width Between Tabs
Uses 1/2" Shock Bolts
27" Maximum combined total spring length
Typically customers purchase an 10" top spring and a 16" bottom spring. You could run a shorter bottom spring, but anything less than 16", using the flat spring perch, would have the bottom spring flopping on the spring guide because the spring divider will hit the spring guide at full extension.
Setup For Dual Spring Rate
3.0" Diameter
12.0" Travel
32.500" Extended
20.400" Collapsed
2-1/2" x 10" DSC Dual Speed Compression Reservoir
18" Reservoir Hose
7/8" Shaft Diameter
1-1/2" Mounting Width Between Tabs
Uses 1/2" Shock Bolts
27" Maximum combined total spring length
Typically customers purchase an 10" top spring and a 16" bottom spring. You could run a shorter bottom spring, but anything less than 16", using the flat spring perch, would have the bottom spring flopping on the spring guide because the spring divider will hit the spring guide at full extension.
End Loop and Perch Info
The shock comes with a flat bottom spring perch part number 234-00-166 but you can also purchase the cone shaped spring perch number 234-00-307 to help with clearance issues.
If you purchase the cone shaped spring perch number 234-00-307 you can still use the 10" upper 16" lower.
The shock comes with the 2" (1.950") top edge to center short bottom end loop part number 213-01-237-A. You can also purchase any of the longer end loops listed below.
IMPORTANT: This internal bypass shock has a 7/8" shaft, uses the smaller COM10 5/8" uniballs, 1/2" bolts, uses a plastic spring divider, and is an inch shorter than the 981-30-101 non internal bypass shock. The 981-30-101 non internal bypass has a 1" shaft, uses AIN12T 3/4" uniballs, 5/8" bolts, a billet aluminum 3 piece spring divider and is 1" longer than the above IBP shock.If you purchase the cone shaped spring perch number 234-00-307 you can still use the 10" upper 16" lower.
If you're upgrading from a non IBP shock to this IBP shock, you could purchase longer end loops (213-01-235-A), and make your own tube type shock bolt spacers, instead of the 5/8" to 1/2" stepped reducer spacers, to retain a 5/8" bolt.
