Fox Shocks 803-01-213 Nitrogen Filling Tool For 1/8" Allen Seal Screws

Some Fox shocks don't have a rubber pellet for a needle tool and they don't have a Schrader valve. Instead you'll use this tool. This tool has a 1/8" allen hex on the tip of it.

The large hook wraps around the shock body. You thread the main stem up against the shock body and insert the allen wrench. Then you use the large black wing nut on the back of the tool to unthread the allen plug allowing you to fill the shock. Once you've filled the shock, you then thread the allen plug back into the shock body and disconnect the tool.

Alternatively, if your shocks are tapped 10-24 thread, you can simply buy RPG's schrader valves listed below and eliminate the need for this clamp tool. The schrader valves are way less expensive than this tool and allow you to use a traditional nitrogen bottle setup to fill your shocks.