Kartek Off-Road Weld On 5" Diameter 0.250" Wall 14 Degree Inclination Clevis For Our Econo Uprights

Weld-on clevis, welds to our two piston or four piston caliper mounting brackets for making your own economy uprights.

Specs:

14 Degree Inclination

5" Outside Diameter

0.250" Wall

4-1/2" Inside Diameter

Drilled For Our 1-1/2" Diameter King Pin and Spacer

2 Piston Bracket Requires 10" Rotor

4 Piston Bracket Requires 11" Rotor

Example:

In an ideal situation, the center point of the spindle's inclination will intersect the center point of the tire. This isn't always possible because of the backspace on your wheel and where the brake hub lands. Often times when you're building a vehicle, you won't already have the brakes, wheel and tire already in hand to fine tune exactly where everything will be.

If your front a-arms are already fabricated, you can draw an imaginary line from the upper uniball to the lower uniball. This will give you an idea of what spindle inclination your vehicle is setup for. Of course, on any vehicle you'll have adjustment points to adjust your camber which will affect what degree you come up with when measuring your inclination.