Kartek Offroad 1.5:1 Ratio Hard Anodized Center Load Rack And Pinion For A-Arm Sand Cars
California Prop 65 Warning: This item may cause cancer or reproductive harm. For more info visit p65warnings.ca.gov
Description
If you're replacing a Gear-One brand rack & pinion you'll need to change you're u-joint at the rack because Gear-One uses 3/4" 36 spline. Our billet 6061 aluminum hard anodized center load steering rack and pinion was commonly used on Buggy Works, Desert Dynamics, Desert Rat Buggies (those three used an 11" bump steer bracket) or other A-arm front steer cars.
-
Specs:
- American Made
- Fully Rebuildable
- 3/4" 48 Spline Pinion
- Depth: 2-1/4" (not including pinion or face plate)
- Width: 12-9/16"
- Travel: 4"
- Standard 6" x 1" mounting pattern
- Uses 3/8" bolts and nuts
- Tie Rod Mounting Holes: 1/2"-20 fine thread
- Tie Rod Mounting Hole Width: 1-3/4" on center
- Tie rods must be in FRONT of spindles