Kartek Offroad 1.5:1 Ratio Hard Anodized End Load Rack And Pinion For A-Arm Sand Cars

Our billet 6061 aluminum end load steering rack and pinion for A-arm front steer sand rails.

Specs:
• American Made
• Fully Rebuildable
• 3/4" 48 Spline Pinion
• Depth: 3" (not including pinion or face plate)
• Width: 7-7/8" (body only)
• Travel: 4-3/4"
• Standard 6" x 1" mounting pattern
• Uses 3/8" bolts and nuts
• Tie Rod Mounting Holes: 1/2"
• Clevis Width: 7/8"
• Tie Rod Mounting Hole Width: 14-1/2" on center
• Tie rods must be in FRONT of spindles
• Approx. 1-3/4 Turns lock to lock

Use KTK60414200 bushings (sold separately) to reduce the diameter from 1-3/4" to 1" on the tie rod side of the boots. Or you can use Daystar's shock boot part number KTKBOOT (sold separately) with KTK500F bushings (sold separately) to reduce the diameter from 1-1/4" to 3/4" on the tie rod side of the boots. You'll clamp the boot to the delrin bushing, but you'll allow the delrin bushing to glide up and down the tie rod to prevent the boot from tearing.