PME Driver Side 2-1/2" Hollow Bolt-On Spindle Snout 12 Bolt 4" Bolt Pattern 2-1/2" Spindle Length
California Prop 65 Warning: This item may cause cancer or reproductive harm. For more info visit p65warnings.ca.gov
Description
We call this a Pro 2 snout but it also works on PME's wide 5 VW heavy duty hub kit. Left hand thread spindle for use with PME 5-7/8" (5.9) or PME Series 30 CV billet clevis. 2.360" major diameter on the threads.
This snout is COMPLETELY hollow all the way through. The backside is stepped for a 68mm OD carrier bearing for use on KOH 4400 Ultra 4 Unlimited Class IFS 4 wheel drive Series 30 CV joints and stub axles. Any buggy or truck can use this snout, if your hubs use a 2-1/2" long spindle, just keep in mind that the snout is completely hollow.
Use the twelve point 1" long bolts listed below.
This snout is COMPLETELY hollow all the way through. The backside is stepped for a 68mm OD carrier bearing for use on KOH 4400 Ultra 4 Unlimited Class IFS 4 wheel drive Series 30 CV joints and stub axles. Any buggy or truck can use this snout, if your hubs use a 2-1/2" long spindle, just keep in mind that the snout is completely hollow.
Use the twelve point 1" long bolts listed below.
Dimensions:
Completely Hollow
A Spindle length 2-1/2"
B Shoulder length 1-1/4"
C Flange length 1/2"
D Back shoulder length 1/4"
E Back shoulder diameter 3-3/8" nominal (3.350")
F Flange diameter 4-3/4" nominal (4.725")
G Shoulder diameter 2-7/8"
H Spindle diameter 2-1/2"
Twelve bolt 4" pattern
Uses 3/8" diameter 12 point bolts
18 Threads per inch
2.360" Major diameter on the threads
Backside stepped for 68mm OD carrier bearing
Related Parts
Weld On Backing Plate For 2-1/2" Hollow Bolt-On Spindle Snout 12 Bolt 4" Pattern 3-3/8" Center Hole
