PME Driver Side 2-1/2" Hollow Bolt-On Spindle Snout 8 Bolt 3-3/4" Bolt Pattern 2-1/2" Spindle Length
California Prop 65 Warning: This item may cause cancer or reproductive harm. For more info visit p65warnings.ca.gov
Description
We call this a Pro 2 snout but it also works on PME's wide 5 VW heavy duty hub kit. Left hand thread spindle for use with PME 5-3/8" (5.4), PME 5-7/8" (5.9) or PME Series 30 CV billet clevis. 2.360" major diameter on the threads.
This snout is COMPLETELY hollow all the way through. The backside is stepped for a 68mm OD carrier bearing for use on KOH 4400 Ultra 4 Unlimited Class IFS 4 wheel drive Series 30 CV joints and stub axles. Any buggy or truck can use this snout, if your hubs use a 2-1/2" long spindle, just keep in mind that the snout is completely hollow.
Use the twelve point 1" long bolts listed below.
*Generic photo above
This snout is COMPLETELY hollow all the way through. The backside is stepped for a 68mm OD carrier bearing for use on KOH 4400 Ultra 4 Unlimited Class IFS 4 wheel drive Series 30 CV joints and stub axles. Any buggy or truck can use this snout, if your hubs use a 2-1/2" long spindle, just keep in mind that the snout is completely hollow.
Use the twelve point 1" long bolts listed below.
Dimensions:
Completely Hollow
A Spindle length 2-1/2"
B Shoulder length 1-1/4"
C Flange length 1/2"
D Back shoulder length 1/4"
E Back shoulder diameter 2-7/8" nominal (2.858")
F Flange diameter 4-1/2" nominal (4.40")
G Shoulder diameter 2-7/8"
H Spindle diameter 2-1/2"
Eight bolt 3-3/4" pattern
Uses 3/8" diameter 12 point bolts
18 Threads per inch
2.360" Major diameter on the threads
Backside stepped for 68mm OD carrier bearing