PME Heavy Duty Porsche 934 Rear Micro Stub Brake Kit With 4 Piston Calipers 11-1/4" Rotors 33 Spline
California Prop 65 Warning: This item may cause cancer or reproductive harm. For more info visit p65warnings.ca.gov
Description
Features:
Heavy Duty
Made Using 6061 Billet Aluminum
Hard Anodized - Hubs Will Have A Tan To Grey Appearance
Rotor Diameter: 11-1/4"
Rotor Thickness: 3/8"
Wilwood 4 Piston Calipers
33 Spline 934 Micro Stub Axles (Stubs available with 1/2" thread or 7/16" thread)
3.90" Diameter Micro Stub Bearing Housing (Kit also available with 3.60" bearing assemblies)
14mm 1.5 Thread Wheel Studs
This hub kit by default comes with micro stub axles threaded for 1/2" CV joint bolts. If your CV's have not been drilled out for 1/2" bolts and they still use 12mm bolts then you can also order this kit with stubs threaded for 7/16" thread. Also the kit by default comes with the larger 3.90" bearing assemblies. If the hole on your arm plate measures 3.60" you can also order this kit with the smaller bearing assembly.
This kit is for a STANDARD micro stub trailing arm plate (flat plate). See below picture for reference.
What's Included:
Two 5 Lug VW Pattern (5 on 205mm) Hubs
Two Calipers With Pads
Two Hub Caps
Two Micro Stub Hub Bearing Assemblies
Two 33 Spline Stub Axles
Two Axle Nuts
Specs:
Uses standard DOT 3, DOT 4 or DOT 5.1 brake fluid
1/8" NPT pipe thread inlet (You'll need adapter fittings listed below)
Rotors have 14mm-1.5 thread studs pressed into them (You'll need to purchase lug nuts)
This hub kit by default comes with micro stub axles threaded for 1/2" CV joint bolts. If your CV's have not been drilled out for 1/2" bolts and they still use 12mm bolts then you can also order this kit with stubs threaded for 7/16" thread. Also the kit by default comes with the larger 3.90" bearing assemblies. If the hole on your arm plate measures 3.60" you can also order this kit with the smaller bearing assembly.
This kit is for a STANDARD micro stub trailing arm plate (flat plate). See below picture for reference.
What's Included:
Two 5 Lug VW Pattern (5 on 205mm) Hubs
Two Calipers With Pads
Two Hub Caps
Two Micro Stub Hub Bearing Assemblies
Two 33 Spline Stub Axles
Two Axle Nuts
Specs:
Uses standard DOT 3, DOT 4 or DOT 5.1 brake fluid
1/8" NPT pipe thread inlet (You'll need adapter fittings listed below)
Rotors have 14mm-1.5 thread studs pressed into them (You'll need to purchase lug nuts)