PME Heavy Duty Porsche 934 Rear Micro Stub Brake Kit With 6 Piston Calipers 11-1/4" Rotors 33 Spline

Note: The calipers have a 5-1/4" lug spread so you can still use the same 4 piston trailing arm plate if you're converting from a 4 piston kit to a 6 piston kit.

Features:

Heavy Duty

Made Using 6061 Billet Aluminum

Hard Anodized - Hubs Will Have A Tan To Grey Appearance

Rotor Diameter: 11-1/4"

Rotor Thickness: 3/8"

Wilwood 6 Piston Calipers

33 Spline 934 Micro Stub Axles (Stubs available with 1/2" thread or 7/16" thread)

3.90" Diameter Micro Stub Bearing Housing (kit also available with 3.60" bearing assemblies)

14mm 1.5 Thread Wheel Studs

This hub kit by default comes with micro stub axles threaded for 1/2" CV joint bolts. If your CV's have not been drilled out for 1/2" bolts and they still use 12mm bolts then you can also order this kit with stubs threaded for 7/16" thread. Also the kit by default comes with the larger 3.90" bearing assemblies. If the hole on your arm plate measures 3.60" you can also order this kit with the smaller bearing assembly.

This kit is for a STANDARD micro stub trailing arm plate (flat plate). See below picture for reference.

What's Included:
Two 5 Lug VW Pattern (5 on 205mm) Hubs
Two Calipers With Pads
Two Hub Caps
Two Micro Stub Hub Bearing Assemblies
Two 33 Spline Stub Axles
Two Axle Nuts

Specs:
Uses standard DOT 3, DOT 4 or DOT 5.1 brake fluid
1/8" NPT pipe thread inlet (You'll need adapter fittings listed below)
Rotors have 14mm-1.5 thread studs pressed into them (You'll need to purchase lug nuts)