PME Porsche 934 Rear Midboard Micro Stub Brake Kit With 6 Piston Calipers 11-7/8" Rotors

Note: The calipers have a 5-1/4" lug spread so you can still use the same 4 piston trailing arm plate if you're converting from a 4 piston kit to a 6 piston kit.

Features:

Heavy Duty Race Quality 7075 Aerospace Grade Aluminum

Hard Anodized - Hubs Will Have A Tan To Grey Appearance

Rotor Diameter: 11-7/8"

Rotor Thickness: 3/8"

Wilwood 6 Piston Calipers

33 Spline 934 Mid-Board Micro Stub Axles (Stubs available with 1/2" thread or 7/16" thread)

3.90" Diameter Ten Bolt Mid-Board Micro Stub Bearing Housing

14mm 1.5 Thread Wheel Studs

This hub kit by default comes with micro stub axles threaded for 1/2" CV joint bolts. If your CV's have not been drilled out for 1/2" bolts and they still use 12mm bolts then you can also order this kit with stubs threaded for 7/16" thread.

This kit is for a MIDBOARD micro stub trailing arm plate. See below picture for reference.

What's Included:
Two 5 Lug VW Pattern (5 on 205mm) Hubs
Two Calipers With Pads
Two Hub Caps
Two Micro Stub Hub Bearing Assemblies
Two 33 Spline Stub Axles
Two Axle Nuts

Specs:
Uses standard DOT 3, DOT 4 or DOT 5.1 brake fluid
1/8" NPT pipe thread inlet (You'll need adapter fittings listed below)
Rotors have 14mm-1.5 thread studs pressed into them (You'll need to purchase lug nuts)