Quarter Turn Fastener Transfer Punch Puts A Punch Mark On The Back Side Of Your Panel For Drilling

Fits #5 plates and #6 plates. It will fit into non-dimpled tabs, but it doesn't sit flush. Normally if you're doing large side panels on your car, you would buy a handful of transfer studs so you don't have to lift the panel for each tab you've welded to the car.

A quarter turn panel fastener transfer stud is used to mark a panel for drilling the location of where a tab is. It is used by placing the transfer stud in a tab or body panel mount that is already welded into place. You then position your panel over top of it and lightly tap the panel with a hammer and you'll be left with a mark in your panel where you will drill your hole. It features a deep, straight spring slot which allows the spring to help hold the stud in place.

dzus zeus