Sand Tires Unlimited Padla Trak 1300 Plus Tires 1300 x 15 Plus - No.2 Cut

For years I've been asked, "what size sand tires are best for my vehicle?" It's important to realize that there are TWO major factors in choosing the correct tire for your vehicle. The first is obviously the amount of horsepower and torque that you have. But the second, less obvious, is the amount of wheel travel you have. Often times people will build vehicles with tremendous wheel travel which requires a large diameter tire, BUT the engine and transmission they choose aren't strong enough to carry this load.

If your vehicle has too much wheel travel and too small of a tire, when you launch the vehicle and come down on a hard landing, you're going to bottom out the vehicle on the ground. If you buy the correct diameter tire to compensate for your wheel travel and don't have enough horsepower and torque to turn the tires, then you're going to have a miserable time in the dunes with your engine bogging down.

Rear Sand Paddle Tires:
Now let's figure out what your wheel travel is. See below diagram. If you don't have tires yet, collapse the suspension all the way. Measure from the center of your spindle or axle to the bottom of your chassis. Take that dimension and double that dimension. For example, if from the spindle or axle to the bottom of your chassis, you have 15" then a 30" diameter tire is going to be too small and if you launch the vehicle, you're going to bottom out the car on the ground. You would want several inches from the bottom of the chassis to the ground at full compression because the sidewall of the tire is going to compress if you come down from a hard landing.

After you figure out the diameter of tire that you'll need, the next big question is, do you have enough horsepower and torque to turn these tires?

The Padla Trak from Sand Tires Unlimited is the most popular paddle tire on the market. This series is the classic design which offers the best overall performance for sand cars, sand dragsters, trucks, and Jeeps. What allows it to be so versatile is it's wide design with a short short sidewall and high center crown along with a selection of different paddle cuts. This allows for maximum flotation with a wide selection of levels of 'bite' for your specific application's needs.

You can choose the amount bite a tire has by selecting a paddle number cut. These cuts differ in the paddle height and thickness, with No. 1 being the smallest at 3/4" tall and No. 2 being 1-1/4" tall. Other cuts are available for a few tires and are special order only.

The 1300 Plus Series is a slightly wider version of the 1300 for more flotation and bite for mid travel rear engine cars & swing axle mid-engine cars.

Part Number	Wheel Size	Height	Tread Width	Cut
STU-130015PLUS/1	15" x 10" to 12"	31"	16"	1
STU-130015PLUS/2	15" x 10" to 12"	31"	16"	2