sPOD 07-08 Jeep JK 6 Switch System With Green LED Light Contura Rocker Switches And Source System

Important Note: All of the standard s-pod units use the same circuit board. On the circuit board it comes with three 30 amp fuses and three 15 amp fuses and one main 50 amp circuit breaker. Add up the amperage of all of the accessories that you're going to wire to this circuit board. If for some reason you need to turn on all 6 switches at once, the total amperage that you can run through this box is 50 amps right out of the package. If you exceed 50 amps, the auto reset circuit breaker will shut off until it cools down. The manufacturer sPOD has stated that they put a 50amp breaker on the circuit board to prevent a customer from overloading their alternator. However you CAN change the circuit breaker to an 80 amp or 100 amp as long as your alternator can handle it. The circuit board will handle 100 amps without a problem.


Each system includes all the required mounting brackets and hardware. The system will come pre-wired and ready to install.

Included:
Switch panel, six double light LED Contura switches installed and pre-wired, two piece wire harness set with 8 multi color leads utilizing 18 gauge wires. Each end has an automotive connector made by Deutsch. All wires are wrapped in high temp abrasion resistant nylon braided sleeving.

The 6 circuit power distribution system includes:

• 12 position terminal block for accessory attachment
• 6 Bosch style relays 40 amp plug-in style
• 6 ATO style automotive fuses three 15 amp and three 30 amp supplied
• 6 Diodes to protect sensitive accessories such as LED lights from field collapse
• Inline 50 amp manual resetting circuit breaker
• 8 gauge power leads with crimped and soldered terminal for connection to the battery
• Integrated LVCO (Low-Voltage-Cut-Off) circuit that detects the battery voltage and will cut-off at 10.6VDC and cuts-back in at 12.4VDC so there is enough juice to start your vehicle in case you left an accessory on
• Fuse for LVCO which can be removed to bypass the LVCO
• Mounting bracket for Jeep Wranglers

Highlights of the dual LED option:

• Gives the operator a choice of having a night lighted switch.
• The lower lighted portion of the switch is fully controlled by the operator.
• Prevents from tapping into the OEM electronics.
• Choices of switch LED colors Red, Green, Blue and Amber.
• No extra wiring required by the installer or customer.
• The upper light still lights up only when the switch is in the on position.
• LED's are much dimmer and less distracting
• LED's draw much less power
• LED's have a much longer life span than incandescent lights.