sPOD Self Contained System Includes 6 Contura Rocker Switches Prewired With Relays And Fuses

Important Note: All of the standard s-pod units use the same circuit board. On the circuit board it comes with three 30 amp fuses and three 15 amp fuses and one main 50 amp circuit breaker. Add up the amperage of all of the accessories that you're going to wire to this circuit board. If for some reason you need to turn on all 6 switches at once, the total amperage that you can run through this box is 50 amps right out of the package. If you exceed 50 amps, the auto reset circuit breaker will shut off until it cools down. The manufacturer sPOD has stated that they put a 50amp breaker on the circuit board to prevent a customer from overloading their alternator. However you CAN change the circuit breaker to an 80 amp or 100 amp as long as your alternator can handle it. The circuit board will handle 100 amps without a problem.


The best part about the self contained system is that the circuit board and the switch panel are all in one unit. It can be mounted under your dash or anywhere else on your vehicle. This self contained universal system is very compact (8" wide 8" long x 3" thick) and is a turn-key solution for power/switch control for:

• Utility Trucks/Vehicles
• Trailers
• Chase Trucks
• Recreational Vehicles
• Camping Trailers
• Work truck beds with tool boxes
• Expedition Trailers/Vehicles
• UTVs
• Side-X-Sides
• Sand Rails
• Dune Buggies
• Baja Bugs

Made in the USA!
Easy to install. Comes fully wired and integrated. No assembly required. Two battery cables and 4 holes required for mounting using supplied 1/4-20 hardware. No wiring required, no messing around with switches, relays, fuses and cable routing. Easy access to add your accessories & just a Phillips-head screwdriver is all that is needed to attach your accessories. Just attach the positive and negative wires to any of the 6 outputs on our source, flip a switch and you're done.

The self contained system 6 Circuit power distribution system includes:

• 6 single incandescent lighted switches
• Heavy duty 14 gauge mounting bracket formed, welded and powder-coated
• 12 position terminal block for accessory attachment
• 6 Bosch style relays 40amp plug-in style
• 6 ATO style automotive fuses three 15 amp and three 30 amp supplied
• 6 Diodes to protect sensitive accessories such as LED lights from field collapse
• Inline 50amp manual resetting circuit breaker
• 8 gauge power leads with crimped and soldered terminal for connection to the battery
• Integrated LVCO (Low-Voltage-Cut-Off) circuit that detects the battery voltage and will cut-off at 10.6VDC and cuts-back in at 12.4VDC so there is enough juice to start your vehicle in case you left an accessory on
• Fuse for LVCO which can be removed to bypass the LVCO
• Mounting bracket with hardware (paper drill template included)